coin cell co

RELATED FAQS

Question
Answer
Coin cell replacement is not immediately registered by the CT5000 firmware.
Performing a processor reset (pressing and releasing the RESET button) will register the new coin cell.
Coin Cell part number is CR2025 - 3Volt Lithium - available at most any battery store.
The coin cell Nuisance Delay on CO200 and CO250 can be temporarily disabled using the Schlage Utility Software.
Once disabled via the SUS application, the CO lock will no longer delay the access for valid credentials.
If your CO lock began indicating a low coin cell (Nuisance Delay) after a door file has been downloaded, the coin cell is low and should be replaced. (CR2032)The coin cell Nuisance Delay will be "A...
The coin cell Nuisance Delay settings in the SUS application is not available until such time that a Door file is successfully downloaded to the lockset.
The coin cell is ignored when the lock sets are used with Manual Programming ONLY or while in Construction mode.
The coin cell for the AD and CO family of electronic lock products is a 3vdc lithium. CR2025 is the specified part number.
Coin cell replacement is not immediately registered by the AD200/250 firmware.
Performing a processor reset (pressing and releasing S1 on the Main PCB Assembly) will register the new coin cell.
Cycling lock power (i.e., disconnecting and reconnecting the "AA" battery pack) will register the new coin cell.
The coin cell part number is CR2025 - 3 volt lithium - available at most battery or electronics stores.
There is not a coin cell on the CO100.
The coin cell battery is not used by the WRI400.