D series driver

RELATED FAQS

Question
Answer
The A700-009 driver was obsoleted August 2005 and was replaced with the A700-039 driver and A700-041 finished cap.
The Schlage full size interchangeable core (FSIC) prepped B560F, B561F, and B563F deadbolts all require a UL fire cup (R) in order to be UL listed.  This fire cup is s...
The new AL FSIC driver part number is A700-052.  This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring.  Th...
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert.  Spring cage and driver replacements for AL locks manufactured before this design ...
The part number for 98/99 series NL Drive Screw is 970441-89. The NL Drive Screw is also available in package of ten, part number 090074-00 NL Drive Screw can't be substitute with a standard sc...
There are several part numbers available: Part Number Contents 09-774 SFIC driver & Spacer N523-091 SFIC driver D500-000 Spacer
This is usually caused because the wrong tailpiece is being used on non-IC cylinders or the incorrect driver for IC options. Use the below descriptions to identify which they need.NON-IC: There are...
The ND-Series FSIC driver is part number N523-127.
Verify the door thickness is 1 5/8" or greater per the pricebook.  Thin doors will force the clip off the housing.  If door thickness is correct then replace the product as needed.
The B220-001 is an FSIC rim tailpiece and driver.
There was a design change in 2001 for the driver and lever insert on the AL for SFIC products.  Changing the driver and/or lever insert on locks manufactured prior to 2001 will requi...
 The SFIC lever insert part number prior to 2001 was the A700-022.
Von Duprin 98/99 NL drive screw is located in back of the 98/99 center case assembly. NL drive screw should be left in with trim lock slide plate in up position in the 98/99 exit device with E99...
Tailpiece
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores.  When these spacers are not ins...
Q330-168 SFIC Tailpiece (throw member for levers) Q330-169 SFIC Tailpiece (throw member for knobs) 
The small format core throw member for the AL locks is C604-381.
Schlage ND-Series tailpieces for extended doors are available by only two means, but are not available to order separately. If an extended tailpiece is needed, then a complete lock will need to ...
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.
The cam screw uses a T-10 and the housing screws use a T-15 driver.
The Schlage SFIC rim cylinder driver is part number B520-365, shown below.     Figure 1: SFIC Rim Cylinder Housing
Dimensions can be found here.
Issue:  Schlage SFIC mortise cylinders have potential for the driver pins to fall out affecting the ability to lock and unlock the device.Facts: Housings manufactured between 06/01/2...