dip switch settings

RELATED FAQS

Question
Answer
Caution: Resetting/cold booting a biometric handreader resets the handreader to factory default settings and erases the user database. To reset or cold boot a biometric F-Series handreader with ...
The newer "programmable" RF transmitters/receivers will not work with the older "dip switch" transmitters/receivers. The frequency and coding are different.
With the SUS connected to the AD400, in the EDIT tab there are radio communication settings "FIRST/DELAY/RETRY." FIRST - Is the first delay after the initial transmission of credential data, befor...
AD400 factory default settings when shipped are FIRST = 300 (m sec), DELAY = 200 (m sec) and RETRY = 5  
To change FIRST/DELAY/RETRY connect and couple the SUS/HHD to the AD400 and find under the EDIT tab the FIRST/DELAY/RETRY settings. See notes Or connect the SUS/HHD t...
There is a total of 4 red buttons on the front of the Senior Swing control box. To turn on the display, press and hold any 2 of the 4 red buttons at the same time for approximately 3-5 seconds. Y...
The easiest way to determine if a biometric F-Series handreader has a F1 or a F3 style main board is to look at the back of the unit.  If there are dip switches, then it is a F1 style main board wh...
The following technical note describes in detail the process for upgrading a biometric F-Series HandKey or a biometric F-Series HandPunch F1-style main board with additional RAM.  Please ...
The best way to determine which memory an F-series hand reader needs is to look at the version of the main circuit board.  If the main circuit board has a white reset button, it is an F3 versi...
To program the 8310-865 receiver: Set the dip switches 1 to the "OFF" (pulse) position. Set the dip switches 2 to the "OFF" (0.5s) position. Momentarily press the " No Delay" or "Delay" ...
RX wiring on all L9000 locks with RX switch manufactured after January 2, 2017:The L-Series switched to a handed modular three-wire request to exit (RX) switch. This change was originally completed...
Specific to the RX switch installed into the L9080EL/EU and L9082EL/EU and L9000 mechanical locks prior to January 2, 2017:ALL PART NUMBERS BELOW DISCONTINUEDThe L-Series switched to a three-wire r...