Parts manual for H series

RELATED FAQS

Question
Answer
The Falcon T Series lock does not have an RX switch available.
To convert the AL44 to an AL40 you can replace the outside plunger unit in the chassis or order the AL40 chassis.  Replacing the plunger unit is more difficult and time consuming and would not be r...
XL11-515 is an option for lead lining on the L9000 series mortise locks. XL12-216 is an option for lead lining on the L400 mortise locks.
To remove the M lock trim follow the steps below in reverse.       The M lock spanner wrench is 021415.  Although this wrench is no longer available from&n...
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...
As of May 23rd, 2011 the H lock utilizes the B500 bolt.  If the deadbolt is being replaced for an existing lock, the linkage and housing will change as well.  The new linka...
Reference the L-Series Service Manual to change lock functions or build up a case from parts.
This Step-by-Step guide is specifically designed for the functions listed below, however, it can be referenced with a majority of L series functions since most of the parts are ...
Only the Schlage D-knob and ND products are available with an extra long backset.  The part number for backsets over 5"-42" is XC03-069, this part will ship as an extension link to be used with a s...
The G-Series lockset was discontinued in 1981, and all service parts for the G-Series lock were discontinued in 1985. 
 The current interconnect lock, S200 series (available in levers only), will not fit into the same door preparation.
The knobs are available, part numbers listed below. 01-008 for a closed knob 01-009 for open levers 01-018 for cylinder knobs, LEV lever design not available in 01-018 01-026 for FSIC Specif...
Von Duprin has a maintenance kit part number 050046-00 and maintenance instruction, part number 941079-00 for 98/99 series devices. There are some common parts between 98/99 series and 22...
As of May 23, 2011 the Schlage H-Series is assembled with the Schlage B500-Series deadbolt and a new linkage. If the deadbolt is being replaced for a lock manufactured prior to May 23rd, 2011...
  Schlage H-Series Escutcheons    Part Number  Description Dimension   07-057  Inside escutcheon and turn  6.92" x 2.75"  07-035  Inside escutcheon, dummy - H170  6.92" x 2...
To remove the knob:  Turn key 45 degrees clockwise Push in catch push pin and pull off knob  
*The older wafer style locks did not use a knob catch.  The chassis must be disassembled before the knob can be removed because it uses the wafer lock chassis spindle.
Standard mounting packages are only for a 1 3/4" thick door. Door thickness other than 1 3/4" need to be specified when ordering the device.