qel wiring harness

RELATED FAQS

Question
Answer
The 900-2Q board is no longer available. For warranty purposes, QEL conversion kit and 900-2RS board are required. The 900-2RS replaces the 900-2Q board.
You can use the new QEL+ device with 900-2Q option board.
The old MPB842 power supply will power up to two EL electric panic bars but will not power the QEL devices.  A defective potted module inside the electric panic bar or defective power supply coul...
Calibration is an internal process of the QEL device when energized the 1st time.  The solenoid will pull and drop 3 times on a standard calibration.  Calibration can be forced by pr...
If a vertical rod device, verify the vertical rods are adjusted properly and there is not a bind at the strikes.  Make sure the push bar is not binding at the pushbar guides or any other ...
The new QEL motor has a label affixed to the cover, the older QEL motor has no such label.  See attached image.
EL wiring harness is no longer needed with new EL potted modules.
The current (digital control box) activation input wiring harness (# 761464-00) is included in the Sr. Swing parts bag (-518), and has 4 wires in it, Black, White, Yellow, & Gray. This harness p...
The 8310-877 Bodyguard Safety Sensor attaches (plugs in) to the P1 connector on the Senior Swing controller. The 8310-846 (761462-00) wiring harness "included" with the 8310-877 safety sensor is us...
The male and female receptacle wire assemblies (wiring hardness) are included in 48/9854 and KR48/9854 mullions. The wiring harness is the same in a 4854 and 9854 mullions. 105987 is the part n...
Yes, the QEL device includes a cable assembly part number 110388-00.Since 12/2014, that cable comes in a package (part 116549) with the long cable mentioned above and the small cable that plug...
The EL wiring adapter is not needed for QEL devices.
Chexit devices shipped after 8-24-2015 with motor driven has a twelve wire connector wires and is keyed and can only plugged into the Chexit module in one direction.Chexit devices shipped...
The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.