STEELCRAFT SECTION MORTISE LOCK PREP

RELATED FAQS

Question
Answer
The minimum rose that can be used on the 61L (ANSI/BHMA A156.115.18) preparation is 3 7/16". Steelcraft's 61L lock prep (often referred to as the "Squashed Turtle lock prep") is designed for Bored...
Standard Doors: standard inverted bottom channels will accept the following manufactures automatic door bottoms: National Guard (320) Pemko (420) Zero International (355/354)
Special (custom) option: a special/optional end channel that will support the following manufactures: National Guard (422/423/522) Pemko (443) Zero International (360/364).
Electrical hinges or a power transfer units are the most commonly used practices to run electric power to locks and/or strikes. Electric Hinges: Most electric hinges will fit into a standard 4 ...
See image, ANSI A115.1 Mortise Lock PrepThis door prep requires the N escutcheon with the L283-029 spacer kit to keep the springcage from falling into the door.  Spacer kits are...
Raceway availability: Optional factory installed raceways are available in doors but are not available in frames. Preparation Info: Steelcraft installs a flexible 1/2" ID steel conduit through the...
There are several Schlage and/or Falcon locks that have been tested and approved for this application. For Commercial use the locks have been tested and approved as assemblies wit...
86, 86ED, 86EDR, 86EDV, 86R; Sectional Trim, mortise hinge, deadlock, door bottom
Lock Prep, Mortise lock Prep, Edge Prep Only with RPD reinforcements; ANSIA115.1, Door Lock Prep