Where is the EPT location of a Pin-and-Barrel Continuous HInge?

The 600/700 Series EPT Template shows recommended locations based on the standard sizes,

The customer can provide a different dimension measured from the top of the hinge to the Centerline of the EPT cutout if desired, please avoid the cluster of screws at the top of the hinge and the same space at the bottom of the hinge.

Note that custom lengths are made by cutting the bottom off of a larger hinge.

 


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question