Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

Why is my Von Duprin CX going into a weak alarm after the rearm delay?

Chexit devices shipped prior to 8-24-2015 with solenoid - the solenoid pulls and drops, the alarm sounds, there is a solid LED or no LED light after the rearm time could occur for the following reasons:

  1. Wrong power supply. Required Von Duprin PS873 or PS914 power supply. 

  1. Wrong gauge wire or wire run greater than what is recommended.

a.       0-100 ft 14 gauge wire

b.      0-200 ft 12 gauge wire

  1. Wrong size fuse in the PS873 power supply. Required 4 amp slow blow fuse.

  1. If yellow and green wire going into the solenoid from Chexit module provides continuous 24VDC, it will cause an alarm with solid LED or no LED light. Replace the CX module.

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question
VON DUPRIN PANIC DEVICE SIZING
chexit motor pulling latch
CAN LEVER SHUNT CHEXIT ALARM
device has flashing red light
chexit with trim
qel wire gauge
What gauge are hmd
What gauge are hmd
chexit release delay
CHEXIT WITH AUTOMATIC OPERATOR
chexit goes into alarm when connecting solenoid
qel led status light meanings
alarm sounds continuously when armed
chexit light solid then alarm
chexit solenoid disconnected
Can you use CX with LX?
chex it alarm sounds randomly
No LED light on Schlage Encode
electric hinges wire cx
Chexit with automatic operator
cx device special options
chexit device unlock
Chexit assembly > solenoid
chexit board not lighting up
Chexit wiring harness
can we use other cylinder for chexit
Wire gauge run chart
delay on make
NLOP come with pull
Qel red light
chexit with senior swing
chexit with automatic operator
wiring for rxqel device
green and red indicator
chexit with SD
Wire gauges for Von Duprin Exit
chexit led indicator
Is CX delay field selectable
chexit release delay
chexit wiring assembly
chexit & LBR
Chexit infinite delay
fsic for chexit device
Chexit fail safe
what wire Gauge for power supply
Why does my LCN closer DELAY not function?
chexit no alarm
alarm sounding when armed
solenoid not unlocking
solenoid releases immediately
what gauge or wire is recommended
what gauge or wire is recommended for an electric strike
what gauge wires on von duprin rx?
wire gauge for QEL
Chexit bars INH
wiring for chexit
wiring for chexit DE
solenoid will not fully close
cx with lx
what thru wire hinge should i use with chexit device?
Solenoid pulls and releases
what gauge wire is used for actuators
Von duprin crashbar has Weak retraction
CHEXIT GOES INTO ALARM
WHAT GAUGE WIRE IS NEEDED FOR EL PANIC DEVICE
chexit goes into alarm
what gauge wire should I install
Alarm on Von-duprin delayed egrees devices
chexit pulls in drops and pulls in
von duprin chexit
Chexit device will not alarm and goes into alarm mode
recommended wire gauge CX devices
Solonoid not engaging
chexit alarm with no delayed egress
what is rearm
Chexit not functioning
Chexit solenoid part number
Light blinks but no alarm
chexit wiring assembly
Chexit solenoid part number
qel wire gauge
wire gauge magnetic lock
wire gauge shear lock
CX with LX
Lx alarm sounds whened arm
Alk alarm sounds whened armed
chexit wiring asse
chexit wont alarm
Wiring for chexit device
chexit wiring diagram
NO HORN CHEXIT BORD
chexit goes into alarm when armed
chexit wiring with rex
doorlock buzzing and red light
Solinoid wiring chexit old
wire gauges for qel
cannot program red light
recommended wire gauge
lacth does not drop in
QEL solid red light
WHAT GUAGE WIRE IS REQUIRED FOR MOTOR CHEXIT DEVICE
LX WITH CHEXIT
qel time delay
Qel wire gauge
chexit wire run
CHEXIT WIRING SCHAMATIC
solenoid not working
solenoid not pulling in but stays in when held in
chexit device width
chexit pcb kit
safety clear led is lit
CX not alarming
holds at first then drops
IS CHEXIT DELAY ADJUSTABLE?
chexit with LX
Automatic Rearm for ALK
IF EL DEVICE RETRACTS AND LETS GO WITH NO TIME DELAY
touchscreen light up
Fusion > Lavinia
power supply wiring gauge
chexit not going into alarm
von duprin alarm kit
von duprin alarm kit
CHEXIT WEAK ALARM
what wire guage and run is recommended for von duprin electric strike devices
POWER SUPPLY FUSE
Solenoid not holding
dc light goes out
power supply wire gauge
wire gauge for QEL
CX pulls and releases
Chexit goes solid red when armed
fob green then red light
Touch screen will not light up
chexit goes into alarm when armed with fast flashing red light
wire gauge needed for EL devices
chexit goes into alarm when armed
Resettable thermal fuse
red flashing light on QEL
chexit solenoid test
GATE PULL FOR CHAINLINK GATE
CX not alarming
CX module sounds weak
fast track chexit
what cylinder do I use for CX
Chexit flashes red when armed
Chexit flashes red when armed
chexit field wiring cable
wire gauge for electric stikes
Chexit has solid red LED, then goes into alarm when armed
Chexit alarm does not sound when armed
CX not rearming
CX shorts out
auto rearm on ALK
Cx goes into alarm
gaurd x goes into alarm when armed
does chexit rearm on its own aftr fire alarm
Chexit goes into alarm when armed, led is solid red
chexit wire run
Chexit has fast flashin red light when armed
chexit replacement wires
CX not giving delay
QEL has red flashing light
chexit flashes once when armed, then nothing
chexit goes into alarm when armed with solid red LED
Chexit goes into alarm when armed
what electrical options are available with CX device
ives decorative pull
QEL, red light is solid
Chexit does not provide free egress
MA wiring gauge
Chexit goes into alarm when armed with do delay egress
Chexit led is solid red
Chexit light flashes once
code not working blinking red light
Chexit solid red LED with no sound or buzzer
Chexit is making strange alarm sound
Chexit flashes once when armed
Chexit has not delay
Chexit has solid red light
cx wiring diagram
QEL has solid green light
Solid red light when chexit is armed
Chexit device light not blinking?
Chexit release delay
CX with AO
wire gauge for QEL
ND wire gauge
CX flashing red light goes into alarm
Von Duprin pull handle
qel red light blinking
Solid red light QEL
CX drops power
Chexit goes into alarm when armed with no delay egress
chexit goes into alarm with no delayed egress
QEL light is solid red
chexit with wandergaurd
guard x goes into alarm when armed
cx wire gauge
el wire gauge
Cx pull and and releases
chexit alarm will not sound
solid red led on QEL device
QEL with solid red light
Chexit goes immediate into alarm
chexit has solid red light when armed, then goes into alarm ten seconds later
power supplies fuses
Chexit LED turns red once when armed then nothing
No light on QEL
chexit blinks red when armed with alarm
chexit goes straight into alarm when armed
chexit flashes once when armed, no alarm, free egress
Chexit goes into alarm, no led light, no delayed egress
Chexit goes into alarm when armed, fast flashing red
QEL solid red
Where can I find Chexit wiring?
Wire gauge with QEL
Solid red led on chexit
Solid red light on Chexit
there is not delay with my cx
Chexit goes into solid red LED, then alarm
Chexit goes into solid red light and into alarm
chexit light flashes red, no egress
Chextit is solid red when armed
CX is going into alarm on its own
CX is not arming
cx looks like it armed but no delay
QEL solid red light
solenoid voltage on chexit device
Chexit has red light when turned on, goes into alarm
Chexit has solid red light when turned on, goes into alarm
chexit have fast flashing red light
chexit lights up, has no delay
Chexit - solid red light