Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ada exit devices ”

RELATED FAQS

Question
Answer
What is the minimum clear opening width required by ADA on a single door?
The minimum clear opening width for ADA is 32" measured from face of door opened to 90 degrees to face of stop on strike jamb. There must be no hardware mounted to the door projectin...
Does EL conversion kit for Von Duprin exit devices contain mechanism cover plate?
The conversion kit does not contain a new mechanism case cover plate.  If a cover plate is desired you would need the Fire or Less Dogging Cover Plate for EL conversion kit and panic cover plate fo...
Do we offer a lever trim with squared top and bottom for the 98/99 series exit devices?
The Von Duprin 994L series trims were square on top and bottom.  They were discontinued in July 2010.
Is there any way to lock the push side of an opening with a Von Duprin exit device?
You cannot lock the push side of the exit device as a panic device by design must allow exit.  Any attempt to block an exit is forbidden by code.
How do you route the wires for an E996L trim through the exit device?
The wires run through the device out to the EPT. See step 7 on page 5 of E996L instructions.
Can danmark lever designs be used on Von Duprin Exit Device trims?
Von Duprin does not offer any of the danmark lever designs by Schlage.
Do Von Duprin Exit devices meet the 5 pound force requirement for opening an ADA handicapped door opening?
The 5 pound force requirement is in reference to the maximum force to swing the door, not the maximum force allowed to unlatch the exit device.  Maximum allowed force to retract the Von D...
Is the B500 and B600, B700, B800 thumbturn ADA compliant?
The Schlage B500-Series and B600/700/800-Series have ADA compliant turns.  See our deadbolt literature under downloads.
Does the 8827 with the 248L-4 strike meet ADA?
The 248L-4 strike will not violate ADA.  If you change the 248L-4 to the 304L strike, then the latch would need to be lowered.
Are the D100 and D200-Series thumbturns ADA compliant?
The D100-Series and D200-Series have ADA compliant thumbturns. See the sell sheet stating ADA compliance.
How do you order the L series lock with an ADA thumbturn?
Effective December 9, 2019, Schlage L Series mortise locks with a thumbturn will ship standard with our new ADA thumbturn. The new ADA thumbturn is slightly smaller than the existing design while s...
Is there an ADA thumbturn offered in the MA locks?
Falcon does not offer an "ADA style thumbturn.
Are Ives pulls ADA compliant?
8103EZ and 9103EZ have 2 1/2" clearance the other pulls have 1-1/2" clearance. Check with your local code for clearance required.
Can a 4040 open to 180°?
The 4040/4040XP closer mountings have the following maximum opening degree templating: The 4040/4040XP PA "Regular Arm" mount will allow for 180° max. opening. The 4040/4040...