adjust bottom rod

RELATED FAQS

Question
Answer
Required top and bottom rod adjustment. Top rod possibly is adjusted too short and not lifting the rod far enough to engage the latch retention which would cause bottom rod to drag floor ...
Following parts are required to add the bottom rod and latch to the 98/9927-LBR/LBR-F device.  Bottom Rod: 050515 for 9827 and 050514 for 9927 (specify finish)  Bottom Latc...
This is available. If this is a fire rated opening you must use the Auxiliary Fire Latch Kit to maintain your Fire Rating.  If not fire rated simply omit the bottom rod but be aware that your...
The 6111 electric strike can be used only on non rated openings less bottom rod with pullman top latch (use ES prefix when ordering device). Device back set will change to match the centerline of t...
Not for use in fire rated openings.
The following items may cause the exit devices top latch from being held in the retracted position. 1. The top or bottom rods are out of adjustment. 2. The top latch hold back...
Following exit devices 2227/F, 33/3527A/F, 33/3547A/48A/F, 98/9927/F and 98/9947/48/F have similar rod adjustment procedures. All top latches control the bottom latch assemblies. When do...
The Von Duprin 2227 or 2227-F  exit device is available less bottom rod.  Specify 2227-LBR or 2227F-LBR for fire.
The top and bottom rod itself is 35" long standard.
One of the following items may cause the EL1690 device to retract then release: Incorrect power supply - Verify you have the PS873-2/4TD or PS914-2RS/4RL power supply. Problems with wire gauge...
The internal rods and latches for the 25-C carried over from the older 18-C device so they can be used interchangeably.