Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ alarm kit installation ”

RELATED FAQS

Question
Answer
What are the Von Duprin part numbers for RX, LX and RX,LX-LC switch kits for field installation?
The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.
Do we have conversion instructions for the E996 when shipping conversion kits?
We ship the standard installation instructions because it contains enough information to show how to convert the trim from mechanical to electrical.
Can a Von Duprin 996L trim be converted to E996L trim?
A E996 conversion kit is required to convert the 996L/L-BE trim to E996L/L-BE electric trim. 050672-00 is the electric conversion kit for 996L rim or vertical rod exit device. 050673-00 is the ...
Why would an exit alarm ALK go into alarm and shut off after about 10 seconds?
If the spring on the Von Duprin exit alarm ALK board is not located correctly as shown on the instructions, then the vibration from the horn allows the cylinder to turn and shut the exit alarm ALK ...
What is the part number for the ALK sign?
The sign for exit alarm, ALK, is SIGN-1.
What is the part number for the EAK PCB only for Monarch Falcon devices?
PCB only for the Alarm Kits prior to June 11th, 2012 is part #650335 and was used in the older 17 & 18 devices, 19, & pre June 2012 24/25's.
This circuit board will NOT work on the updated 24/25 Alarm Kits that released June 11th, 2012.
What is the current draw of a Von Duprin exit alarm kit ALK?
The current draw of a Von Duprin exit alarm ALK is .25 amp when alarm is activated.
If using the alarm kit-ALK with the 99 device what power supply is needed?
Exit alarm ALK operates with 9VDC battery and doesn't required a power supply.If you choose to hard wire the exit alarm ALK use the PS902 power supply.Exit alarm ALK requires 24VDC regulated power ...
What cylinder is used in the Falcon 24/25 exit alarm kit?
The Exit Alarm takes a 1 1/8" Mortise cylinder with a straight cam. See first page of Exit Alarm inst below. Exit Alarm inst
Is there an Exit Alarm Retrofit Kit (EAK) for the 19 series?
These kits for the 19 Series were discontinued June 11th, 2012 when the updated alarm kit for the 24/25 series was released.   Prior to discontinuation, it was  o...