For motor driven Chexit devices shipped from the factory after 8-24-2015, the RX switch is standard, part number 116717-00.
Note: A slight change to the plastic housing was added in Nov...
For solenoid driven Chexit devices shipped from the factory prior to 8-24-2015, the RX switch is no longer available. This part was discontinued in 2019.
If the older version Chexit RX s...
The RX switch can be installed at the factory when device is ordered or in the field with part# 650359-00. Installation instructions here will show how the RX swi...
These kits for the 19 Series were discontinued June 11th, 2012 when the updated alarm kit for the 24/25 series was released.
Prior to discontinuation, it was o...
This option is not available. The 17 & 18 Series devices were discontinued in August 2009 and the new Falcon RX Switch is mounted to a bracket that fits in the pushpad...
Exit alarm ALK operates with 9VDC battery and doesn't required a power supply.If you choose to hard wire the exit alarm ALK use the PS902 power supply.Exit alarm ALK requires 24VDC regulated power ...
The following may cause the ALK to go into alarm:
Make sure red and blue wires on the RX switch are connected to the exit alarm ALK terminal block and yellow wire is taped off.
Check the red an...
Yes. The exit alarm ALK is shipped standard with a RX, request to exit switch, but can work with the optional LX, latch bolt monitor switch. If there is no switch in the device it will never alarm.