Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ are arms interchangeable on LCN closers ”

RELATED FAQS

Question
Answer
Can a Cam Lift hinge be used with LCN closers?
Cam Lift hinges can only be used with LCN door closers that have a "Regular" style arm.             Manual Closers: Maximum li...
What is the difference between the 2030 and 5030 closer?
2030 and 5030 are both overhead concealed closers. The 2030 uses a concealed, in the door, track, and a concealed one piece arm. The 5030 uses a exposed double lever arm (like the arm for a 401...
How do I set the hold open on my 4040 closer?
The hold open position on a "REG" or "EDA"  hold open arm is set with the door to a few degrees shy of the desired hold open point. To properly set, open the door 5° less then the desired hold open...
Can a 1460 EDA open to 180°?
The standard 1460 EDA arm is not long enough to allow the door to open 180°.
Can I mount an LCN Cush closer with an GJ overhead stop?
It would be unnecessary to use the CNS/Cush arm and the Glynn Johnson overhead devices in the same application, both mechanisms stop the door.
Which arm is the same as the 4640 regular arm?
The 4640 Regular arm (4640-3077) is the same as: 4040 Long Arm 4820 Regular arm. The arms listed above are for reveals up to 4 1/2" and have a 8 3/8" long rod and shoe. 4640 Long arm ...
How do you install the LCN 9540 Senior Swing (REG) push arm?
When installing the arm; the gearbox shaft  and door must be at the (+90°) full open position. The following step are used to install the Sr. Swing (REG) push arm. Install the header and door brac...
What is the difference between an LCN CUSH arm, and an LCN EDA arm?
EDA ARM - The EDA arm is a heavy duty parallel arm mount.  The degree of door opening is determined by the template used for mounting. EDA arm closers can only be mounted as a Push Side parallel ar...