Grouting frames is:
A process done in the field during hollow metal frame installation
The internal cavity of the frame is fill with masonry or mortar
It is intended to mainly provide ...
Steelcraft offers two optional types of reinforcements for open section header to be installed in distributor shop or in the field:
Full profile sleeve; is a 14 gauge, 16" long part to fit the p...
For both DW and K-Series Drywall Slip-on frames, Steelcraft locates the compression anchor in the jamb soffits approximately 4" down from the head on each jamb. Regardless of door opening height:
...
Industry standards for hollow metal frames installation tolerances have been developed by both the SDI (Steel Door Institute) and HMMA (Hollow Metal Manufacturers). Both standards are based on the ...
This condition (toed in or toed out jambs) is usually not found until the door is installed.
Frames which have toed in or toed out jambs have been installed out of tolerance.
It is the resp...
CAUTION must be used in investigating this problem - In most cases, excessive field rusting of products is caused by improper storage at the jobsite. That situation must be validated prior to refus...
Yes, as an option, Steelcraft doors are available with factory prepared for the 98/9949 Concealed Vertical Cable Exit Device.
L, B, CE, T and CE-Series doors are available factory prepared
Door...