These cylinders are designed with a microswitch attached to the back of the cylinder. The switch is operated by a cam when the key is rotated.
To order:
XB09-195
Mort...
The XB09-195, XB09-795, and XQ11-804 are basically modified mortise cylinders. The overall length of the mortise cylinder switch is approximately 1-9/16" (1.563"). The diameter of the cylinder face...
Standard 98/99 exit alarm ALK devices are available with cylinder dogging option as of October, 2011.
The device can be ordered standard with cylinder dogging and exit alarm ALK opti...
The Von Duprin CD kit comes with the cover plate machined to accept the cylinder dogging mortise cylinder.1 1/4" mortise cylinder with an inverted straight cam is required for CD option on Von Dupr...
The 38-070 is a dummy mortise cylinder available in 1 1/8", 1 1/4", 1 3/8", 1 1/2" lengths. The cylinder has an embossed faceplate to look like a standard cylinder but no keyway.
The 38-070 is not available in stainless finishes; 629 and 630.
A 1 1/4" mortise cylinder with straight cam (similar to the Schlage B502-191) or a 1 1/2" mortise cylinder with straight cam using supplied spacer collar.
Cylinder length does not chan...
1 1/8" mortise cylinders fit the 650 series keyswitch.
The 650 series keyswitch when ordered with the cylinder, will come complete with the correct cylinder, cam, and any required blocki...
If blocking rings (PN 36-079) are needed, specify dimensions when ordering. See below for blocking ring (PN 36-079) dimensions.
Blocking Ring
Specify Dimension
1//8"
...
Chexit devices shipped after 8-24-2015 with motor driven:
The Chexit device will use a 1 1/4" mortise cylinder with straight cam. Schlage cylinder 20-001-114 recommended.
CAUTION: The length of t...
Chexit devices shipped prior to 8-24-2015:The CX device will need a 1 1/4" mortise cylinder with a straight cam per page 2 of the installation instructions. A 996L-M for a 1 3/4...
There are different mortise cylinder length options depending on the cylinder type. Below is a list of available options for conventional, FSIC, and SFIC cylinders, as well as the convent...
The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece. Because of allowable tolerances for each part the average length is l...
A modular cylinder's length is determined by 4 basic parts; a cam screw, cam, plug extension, and a back housing. Most of these parts are used in more than one cylinder length and...
Key-in-lever tailpieces differ in length depending on the lock series, function, and design. Click here to identify the tailpiece and length.
NOTE: Modular cylinders use...