Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ chexit and EL ”

RELATED FAQS

Question
Answer
What gauge wire is needed for a CX device?
For devices shipped after 8-24-2015 with motor driven:  a.       0-200 ft, use  #18 gauge wire b.      0-500 ft, use #14 gauge wir...
For Product Shipped prior to 8-24-2015 with solenoid driven:          a.       0-100 ft, use #14 Gauge Wire      b.&n...
Can Von Duprin QEL/EL and CX be in the same device?
You can not use these options together on the same device per the following reasons: QEL/EL device retracts the latch bolt of the exit device allowing entry. CX (Chexit) device ...
Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?
The hole should be drilled in the field once the end cap is located on the door.  It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...
Is the the PS914 EL wiring adapter needed for Von Duprin Chexit device?
The EL Wiring Adapter is not needed for a CX device.