Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ chexit electrical template ”

RELATED FAQS

Question
Answer
Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?
The hole should be drilled in the field once the end cap is located on the door.  It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...
Why is the electric E996L-FSE trim used with a Chexit CX99 exit device?
The E996L-FSE trim is needed if the application requires fail-secure operation from the trim side of the opening. When power is out on Chexit device, E996L-FSE trim will remain locked to ...
Where can Von Duprin 6300 electric strike installation instructions or templates be found?
 Von Duprin surface mounted 6300 electric strike paper template and installation instruction are provided with the electric strike. See attached 6300 Template & I...
What special template (ST) is used with a 4040 Rw/PA mount closer and a GJ overhead stop?
ST Number Product 1 Product 2 Description ST-2776 4040XP Rw/62A Overhead stop 81, 90, 100, 410, 450 series The standard P...
Will a 4040 Hw/PA hold open at 180°?
The 4041 Rw/PA and the Hw/PA have the same template.  The only difference is the arm. The 4041/4040XP Hw/PA, if mounted to the 180° template, will hold the door open at 180°. Rw/PA is Regular A...
Can a 24-R or 25-R series device use just a cylinder on the pull side for NLOP function?
This is possible: For metal doors prep door according to the 24R/V NL-OP Template or the 25R/V NL-OP Template and for wood doors use 24R/V NL-OP Wood Template or 25R/V...