Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ CLOSER WIDE THROW HINGE ”

RELATED FAQS

What closer can be used with Soss invisible hinges?

Resolution: Using Soss hinges with closers can require special device and preparation locations. If you have questions on specific closer applications, please e-mail your request (including a description ...

Can a Cam Lift hinge be used with LCN closers?

Resolution: Cam Lift hinges can only be used with LCN door closers that have a "Regular" style arm. Manual Closers: Maximum li...

Can a 4010 be mounted with swing clear hinges?

Resolution: Locate closer and arm from the centerline of the swing clear hinge pin.

Can a 450 overhead be used on a 48" wide door hung with butt hinges or offset pivots?

Resolution: The 455 can be mounted on a 48" wide door, but we cannot guarantee that it will withstand the forces involved. Recommend using 906 instead.

Can a 4110 closer be mounted on a 24 inch door?

Resolution: Standard templating will allow a 4110 closer to be mounted on 24" wide door.

What hinges can an EPT be installed with?

Resolution: EPT can be used on following hinges: Degree of the opening Hinge type Door thickness 0-180 degree Up to 5" butt hinges 1 3/4" 0-180 degree Up to 3/4" offset pivots 1 3/4" 0-130 degree 5 1/2"...

Resolution: See related solution: Can an EPT be used with Cam Lift Hinges?

What degrees of opening can a 4110 EDA be templated for?

Resolution: The 4110 EDA/HEDA can be templated for 100°, 140°, and 180° hold open. The hold open adjustment can be set to hold the door at any position (degree) up to the maximum door opening angle. For "Wi...

What are ANSI BHMA hardware grades?

Resolution: The American National Standards Institute (ANSI) and Builders Hardware Manufacturers Association (BHMA) have developed durability, strength and performance standards for every type of door hardware...

Can I use a Glynn Johnson 410 with a 4040 regular (pull side) mount?

Resolution: ST-1630 is required when mounting a 4041 or 4040XP door closer regular (pull/hinge) side with a concealed GJ100 or GJ410 series over head stop.