Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ deviated finishes for button push ”

RELATED FAQS

Question
Answer
How do I change the function on an ND53 to an ND50?
Swapping out the following parts of an ND50 will convert it to an ND53: Swap N123-028 Push button plunger for  N123-017, Push and Turn button plunger Swap N523-000, Push button for N523-001 Pus...
How can I get help for my Locknetics Products?
Locknetics company supplied electro-magnetic locking devices, electronic smart locks, and electronic security components to access control dealers and lock smiths.  Ingersoll-Rand acquired ...
How do you wire a receiver to a 4600 Series operator?
The 4630/4640 operator can accept any ( normally open / dry contact) actuator - hardwired or wireless.  LCN Wireless actuators require the use of the 8310-865 RF receiver.The 8310-856 RF ...
How to change switches on a 8200 Console to maintained or momentary?
The 8200 console has both maintained(8200AS) and momentary (8200MS).
To replace the pushbuttons, remove the switch connector from the console main board Then press the pushbutton from the inside of the panel face out through the hole. There will be some resist...
Will the 25-R or 25-V work with Simplex trim?
The 25-R or 25-V device does meet the trim input requirements set by KABA for their trim so the two should be compatible.  However, the KABA trim has never been tested in house for the Fa...
AL-Series Plunger Assembly Instructions
Changing the plunger assembly on the AL-Series requires disassembling the chassis.  Refer to Plunger Assembly Instructions for guidance.
D73 locking issues with push button.
A design change occurred in 2001 to address a locking/unlocking issue with the discontinued D73 lever locks.  This included modifying the cam and plug, spindle and using a different plung...