Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ falcon exit alarm cylinder ”

RELATED FAQS

Question
Answer
What cylinder is used in the Falcon 24/25 exit alarm kit?
The Exit Alarm takes a 1 1/8" Mortise cylinder with a straight cam. See first page of Exit Alarm inst below. Exit Alarm inst
Can I use CD and ALK on a 98/99 series Von Duprin?
Standard 98/99 exit alarm ALK devices are available with cylinder dogging option as of October, 2011. The device can be ordered standard with cylinder dogging and exit alarm ALK opti...
What cylinder is needed with Von Duprin exit alarm ALK?
The ALK uses a 1 1/4" mortise cylinder with straight cam. (NO DOGGING)
What is the part number for the EAK PCB only for Monarch Falcon devices?
PCB only for the Alarm Kits prior to June 11th, 2012 is part #650335 and was used in the older 17 & 18 devices, 19, & pre June 2012 24/25's.
This circuit board will NOT work on the updated 24/25 Alarm Kits that released June 11th, 2012.
What is different about the updated Falcon Exit Alarm (EA) option ?
The Falcon Exit Alarm option was updated in June 2012 to include the following benefits. Louder Alarm 95dbs vs 87dbs Easier battery changes 24Vdc hardwire(HW) option included w...
Can I put a Schlage Key-In-Lever cylinder into a Falcon D100 or D200 lock?
Falcon D series deadbolts will not accept Schlage Key-in-lever cylinders. The faceplate plug hole is smaller in diameter than the Schlage plug and does not fit flush when i...
For a Schlage "C"  keyway:  Specify "CP6" as the cylinder suffix when ordering  D100 or D200 locks (All other Schlage keyways are not available).