Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ find Parts manual for H series ”

RELATED FAQS

Question
Answer
How do you convert an AL44 to an AL40?
To convert the AL44 to an AL40 you can replace the outside plunger unit in the chassis or order the AL40 chassis.  Replacing the plunger unit is more difficult and time consuming and would not be r...
How do you remove the cylinder from an A series knob?
To remove the knob:  Turn key 45 degrees clockwise Push in catch push pin and pull off knob  
*The older wafer style locks did not use a knob catch.  The chassis must be disassembled before the knob can be removed because it uses the wafer lock chassis spindle.
Does the Falcon T series have an RX option available?
The Falcon T Series lock does not have an RX switch available.
Was the H lock design changed to include the B500 deadbolt?
As of May 23rd, 2011 the H lock utilizes the B500 bolt.  If the deadbolt is being replaced for an existing lock, the linkage and housing will change as well.  The new linka...
What is the part number for a privacy emergency key?
M504-271 is the emergency key used to open a locked S40.
What does the cylinder suffix BDC mean?
A lock specified by a cylinder suffix BDC will be supplied with a disposable small format construction core, see Figure 1 below.  There is no metal key but instead the BDC cylinder has a ...
A small format disposable core is used as a SFIC construction core that is for low security applications and can be thrown in the waste bin after use.
What is an interconnected lock?
Interconnected Locks: a lockset whose trim provides a means of simultaneous retraction of two or more bolts which may also be operated independently Medium duty Commercial, government or multi-...
What is the grading for S200 and H series locks?
Neither lock has a BHMA grade.
Are the Schlage H series knobs sold separate?
The knobs are available, part numbers listed below. 01-008 for a closed knob 01-009 for open levers 01-018 for cylinder knobs, LEV lever design not available in 01-018 01-026 for FSIC Specif...
What is the warranty for Schlage commercial mechanical locks?
Warranty Statement3 Year Limited Mechanical Warranty and 1-Year Limited Electromechanical Warranty - Additional warranties listed below The provisions of these limited warranties do not apply to P...
Are parts still available for the Schlage interconnect G series lock?
The G-Series lockset was discontinued in 1981, and all service parts for the G-Series lock were discontinued in 1985. 
 The current interconnect lock, S200 series (available in levers only), will not fit into the same door preparation.
What does the H-Series housing and linkage look like?
The housing and linkage is what sits underneath the inside escutcheon plate and can be seen in this exploded view.  The linkage is what gives the H lock simultaneous retraction.  It allows the dead...
What size is the Schlage H escutcheon?
  Schlage H-Series Escutcheons    Part Number  Description Dimension   07-057  Inside escutcheon and turn  6.92" x 2.75"  07-035  Inside escutcheon, dummy - H170  6.92" x 2...
Did the H-Series deadbolt and linkage change?
As of May 23, 2011 the Schlage H-Series is assembled with the Schlage B500-Series deadbolt and a new linkage. If the deadbolt is being replaced for a lock manufactured prior to May 23rd, 2011...