FSIC mortise cylinder driver

RELATED FAQS

Question
Answer
The new AL FSIC driver part number is A700-052.  This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring.  Th...
Issue:  Schlage SFIC mortise cylinders have potential for the driver pins to fall out affecting the ability to lock and unlock the device.Facts: Housings manufactured between 06/01/2...
The cam screw uses a T-10 and the housing screws use a T-15 driver.
The Schlage SFIC rim cylinder driver is part number B520-365, shown below.     Figure 1: SFIC Rim Cylinder Housing
The 30-001 is a conventional mortise cylinder with a clover cam, compression ring and spring for use on rose trim. For use with the L9000 mortise locks except for the L9060 outside cylinder.
Chexit devices shipped after 8-24-2015 with motor driven: The Chexit device will use a 1 1/4" mortise cylinder with straight cam. Schlage cylinder 20-001-114 recommended. CAUTION: The length of t...
Chexit devices shipped prior to 8-24-2015:The CX device will need a 1 1/4" mortise cylinder with a straight cam per page 2 of the installation instructions. A 996L-M for a 1 3/4...