Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ inserting driver bar in cylinder ”

RELATED FAQS

Question
Answer
New FSIC driver info for the AL locks.
The new AL FSIC driver part number is A700-052.  This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring.  Th...
What size driver is used to remove the torx screws on a modular cylinder?
The cam screw uses a T-10 and the housing screws use a T-15 driver.
What is the part number for the SFIC rim cylinder driver?
The Schlage SFIC rim cylinder driver is part number B520-365, shown below.     Figure 1: SFIC Rim Cylinder Housing
Which way is the tail piece of the rim cylinder is inserting into the Von Duprin 98/99 rim device from 996L trim?
 The tailpiece of the rim cylinder can be inserted into the Von Duprin 98/99 rim device either vertical or horizontal.
How is the split key construction insert retained in a cylinder?
With split key construction keying there are two ways the construction insert is retained in the cylinder so that it won't fall out the back end of the plug, see Figure 1.  The&nb...
Will the standard cylinder drive bushing on a 1790 device work with my 179L trim?
You must use the drive bushing that is supplied with the 179L control trim.  It is different from teh 1790 bushing.
Step 3 and 4 of 179L Instructions will show the old drive bushing being removed & the new drive bushing getting installed
Does the Von Duprin CD kit include the machined cover plate for the cylinder?
The Von Duprin CD kit comes with the cover plate machined to accept the cylinder dogging mortise cylinder.1 1/4" mortise cylinder with an inverted straight cam is required for CD option on Von Dupr...