Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ installation templete schlage l lock ”

RELATED FAQS

Question
Answer
How do you remove an L lock from the door?
To remove the Schlage L Series from a door reference the appropriate installation instructions found here at https://us.allegion.com/en/home.html
What are the electrical requirements for the Schlage L9000 lock?
Applies to L9090EL/EU, L9091EL/EU, L9092EL/EU, L9093EL/EU, L9094EL/EU, L9095EL/EUThe Schlage electrified L-Series wiring diagram can be found here and the re...
Applies to L9080EL/EU. L9082EL/EU (Discontinued)The Schlage electrified L-Series wiring diagram can be found here and the requirements are listed below. 24VAC or 24VDC (maximum 26V, ...
Click here to show the differences of an installed lockcase between the L9090, L9091, L9092, L9093, L9094, L9095 EL/EU and the L9080 EL/EU
What are the part numbers for the inside and outside knobs for the L series?
Inside knob and bushing: 09-402 plus design and finishOutside knob: 09-401 plus design and finish
Will an L9000 lock fit into a door prepped for the old SCHLAGE K series?
The L Series lock can fit into a door prepped for the SCHLAGE K Series with some additional prep as described here.  
K and L trim and parts are not interchangeable. 
Schlage AL small format spacer installation requirements.
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores.  When these spacers are not ins...
Can you install a Schlage S lever on an AL lock?
You can not install the S lever onto an AL lock.  The AL and S lever trim is not compatible with each other.
What is the offset for the Von Duprin 6211 with the Schlage L 9000 mortise lock?
The center line of the L9000 mortise lock is 7/8" above the center line of the 6211 electric strike. This is the "C" dimension given on the second page of the 6211 template.
Why is the L0170 not available in the L escutcheon design?
The Schlage L0170 is not available with the L escutcheon design because due to the narrow size you cannot fit the mounting plate underneath.  The mounting plate must sit on a "diamon...
What parts are needed to install an L lock on an 1 3/8" door?
The standard L9000 lock can be ordered for thin doors (1 3/8") and the appropriate parts will be shipped.  The LV9000, L400, LM9000, Anti-Ligature, and N escutcheon trims a...
How long does it take to install a L Series mortise lock?
Typical installation by an experienced Schlage L lock installer on a door correctly prepped for the Schlage L-Series function could take 10 to 20 minutes.  Many outside variables can change the amo...