Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ installing al series ”

RELATED FAQS

Question
Answer
How does the AL170 get installed to make a double dummy?
Schlage offers the AL170 single dummy trim, but for applications where a double dummy is needed you can install two AL170 dummy trims back-to-back.  Each AL170 is shipped with a threaded rod (part ...
Schlage AL small format spacer installation requirements.
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores.  When these spacers are not ins...
Why can't a new spring cage or driver be installed on an older AL lock?
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert.  Spring cage and driver replacements for AL locks manufactured before this design ...
Why can't I remove the control key from the core after the core is inserted into the lever?
The lever may be missing the slot feature for the core locking lug.  Verify slot is in place.
Can you install a Schlage S lever on an AL lock?
You can not install the S lever onto an AL lock.  The AL and S lever trim is not compatible with each other.
Does Steelcraft have frame installation instructions?
It is always recommended to point installers to the industry installation manuals which are very comprehensive and are ANSI documents. SDI (Steel Door Institute) installation manual can be found...
Why do AD Series offline locks still give a Low Coin Cell indication after I install a new coin cell?
Coin cell replacement is not immediately registered by the AD200/250 firmware.
Performing a processor reset (pressing and releasing S1 on the Main PCB Assembly) will register the new coin cell.
Cycling lock power (i.e., disconnecting and reconnecting the "AA" battery pack) will register the new coin cell.
The coin cell part number is CR2025 - 3 volt lithium - available at most battery or electronics stores.
What is the part number for our AL series electric strike?
Schlage offers the 10-042 Electric strike, 1 1/4" x 4 7/8", 606 and 626 finish only. Related solution: What are the current and voltage requirements of the 10-042 strike?