Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ installing magnetic holders ”

RELATED FAQS

Question
Answer
How is HB achieved on the 1690 device?
Install the pinion cam at the top of the retractor per Figure 7-3 in Step 7 of 1690 Instructions.
How do I set the hold open on my 4040 closer?
The hold open position on a "REG" or "EDA"  hold open arm is set with the door to a few degrees shy of the desired hold open point. To properly set, open the door 5° less then the desired hold open...
Reinstalling an AD-993 Tailpiece Holder Assembly
Below is the link to the document that shows how to install the AD993 tail piece assembly: Reinstalling an AD-993 Tailpiece Holder Assembly
Can the AD-Series and CO-Series magnetic card credential readers be set to read data from different magnetic card tracks?
Customers will need to use the Schlage Utility Software (SUS) on the HHD lock programming device to set the desired magnetic track to be read for access control, if not using default Track 2&n...
In what direction should the hold open nut be pointing for a 4041 H closer, up or down?
Make sure that the hold open nut is not on upside down.  The orientation of the hold open nut depends on the mounting. On a Top Jamb "Push Side" mount, the hold open nut would poi...