The Schlage SL1 ligature resistant lever is designed to break-away between 100 and 200 inch-pounds. The lever will rotate at this point but not allow access.
The spring in the hinge case or end case assembly lifts the crossbar and both lever arms. If broken, the crossbar and lever arms will drop down. The weight of the crossbar and levers will automati...
The new 33A/35A center case will not work with the old 33/35 series exit devices.
It is never intended to use parts to convert a device from one Series to another Series as this w...
This is not a recommended application as the electric strike does not have the same holding force as the XP98/99 rim exit device. The electric strike has 1500 pounds of holding force whereas the ...
The Falcon Monarch 718C and the 718NL trims can be used on the 25-C exit device.
The 718C trim is listed in the Price Book for the 25 series
The instructions attache...
There is not enough room for both options as the dogging mechanism in a standard cylinder dogging and the electronics for the EL or QEL options are both located at the end of the base plate.
For 9...
The following items may cause the exit devices top latch from being held in the retracted position.
1. The top or bottom rods are out of adjustment.
2. The top latch hold back...
Following exit devices 2227/F, 33/3527A/F, 33/3547A/48A/F, 98/9927/F and 98/9947/48/F have similar rod adjustment procedures.
All top latches control the bottom latch assemblies. When do...