latch too soon

RELATED FAQS

Question
Answer
There are a few things to check in the 912L trim is not retracting the latch  as expected.  If the 912L was shipped after February 28,  2011, Check the installation ins...
Following could cause the bottom latch on 98/9927 exit device to drag. Bottom rod is too long. Adjust bottom rod per instruction sheet 911375. Top latch controls the bottom latch.  ...
The top rod is adjusted too short, so when pushpad is pressed it is not operating the top latch enough to get into the hold down position. The top rod would need to be lengthened by turning the lat...
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device.  Be sure this screw is installed- Exit hardware and strike must be properly mounted ...
Click HERE for the  instruction and template for 237L device.
The resistance readings for a Falcon 24 or 25 Series EL solenoid should read;Green to Yellow = Pull Coil, should measure between 1 and 2 ohms of resistance. Green to Orange = Hold Coil, s...