Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ LCN Special templating with over head stop ”

RELATED FAQS

Question
Answer
Where are hardware templates?
All the templates can be found at us.allegion.comPlease click here
What special template (ST) is used with a 2030 closer and GJ over head stop?
Special template ST-2211 is used to mount a 2030 series closer with a GJ 70,79,81,90, and 450 series overhead stops. This ST works with any GJ "surface" mounted stop. The 2030 closer cannot b...
Does LCN have Torx head wood screws?
Torx head screws are only available as machine screws.
Can I mount an LCN Cush closer with an GJ overhead stop?
It would be unnecessary to use the CNS/Cush arm and the Glynn Johnson overhead devices in the same application, both mechanisms stop the door.
How do you mount an LCN door closer on an arched or radius door?
Can a magnet, or sentronic device, be released and close the door from a button at a desk?
If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiring per ST ...
Does the old style 4030 have the same templating as the new style 4031?
The old 4030 series was: Handed Mounted regular arm hinge side. Had sized springs, were not adjustable. The 4033 is an obsolete closer.  If required, handing can be verified by looking at ...
What is a 1038G closer?
The 1038G is not a closer number, but a cylinder casting number on all the 2030 series closers or a 5030 series closers.