The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece. Because of allowable tolerances for each part the average length is l...
For modular designs:
All functions except ND85 the tailpiece part number is N523-022.
The ND85 tailpiece part number is N523-123.
For non-modular designs:
All functions except ND85 the t...
The Schlage B60 is a residential grade 1 deadbolt and is not available with Everest or Primus cylinders.The B60 deadbolt with a standard cylinder is not available.The B60 deadbolt with a Full Size ...
Schlage offers Falcon Retrofit cylinders to fit many of Falcon's locks. Table 1 below contains part number for T series locks.
Table 1 - Falcon retrofit cylinders
Only the Schlage ND-Series can be prepped to accept non-Schlage cores.
All designs are supplied with the appropriate tailpiece
Non-Schlage cores are NOT included
Lever designs available vary d...
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted.
This will occur if the outside spindle (square post) is install...
This is usually caused because the wrong tailpiece is being used on non-IC cylinders or the incorrect driver for IC options. Use the below descriptions to identify which they need.NON-IC: There are...
The 40-100 is a multiple tailpiece pack with a pre-assembled, 0-bitted, key-in-knob cylinder. The kit includes the following:
(1) Pre-assembled cylinder 0-bitted, less tailpiece 40-100
(...
The pack is available in all keyways, Everest and Classic families including restricted keyways except Primus.
Schlage ND-Series tailpieces for extended doors are available by only two means, but are not available to order separately. If an extended tailpiece is needed, then a complete lock will need to ...
In the AD and CO Series replacement parts guide it shows the same part number 46929295 for the 993R, 993S, and 993M. The pictures show that the 993R and 993S have a flat straight tailpiece and the ...
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core). The tailpiece shown below is used for both...
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces
Key-in-lever tailpieces differ in length depending on the lock series, function, and design. Click here to identify the tailpiece and length.
NOTE: Modular cylinders use...
Standard Schlage rim cylinders will fit a total thickness of door and projecting trim of 3 inches, this includes a minimum of 3/8" of engagement of the tailpiece into the exit device. See ima...
For total thickness measurements larger than 3 inches see the special cylinder offerings in Pricebook. Specify the part number and include the total thickness. We do not offer the ...
The Schlage full size interchangeable core (FSIC) prepped B560F, B561F, and B563F deadbolts all require a UL fire cup (R) in order to be UL listed. This fire cup is s...
The part number for the AD or CO twisted tailpiece kit is: 46929303
Tailpiece Kit - (for Exterior Escutcheon -993 into Exit Device, i.e. Von Duprin 98 or 99)
Exit Trim
46929303 Includes the...