Locks for front door

RELATED FAQS

Question
Answer
Dummy mortise trim without a lock case (L0170/L0712) is used on an inactive door. You can use an electrified mortise with a door position switch on the active door. The strike prep must be co...
The standard L9000 lock can be ordered for thin doors (1 3/8") and the appropriate parts will be shipped.  The LV9000, L400, LM9000, Anti-Ligature, and N escutcheon trims a...
This change was implemented in firmware package CO.A.6 (or later) to help the customer in the communication and coupling process between the CO200 (CO250) and the hand held device (HHD). ...
The green LED is to be lit up until the spindle (Triangles and Key Switch) are aligned properly; providing a visual indication of the problem.  
If the mechanical alignment of the triangles on the back of the outside escutcheon are not aligned, the CO200 or CO250 will not connect with the SUS/HHD and will appear to be unresponsive...
In firmware CO.A.6 (or later) the Schlage button on the CO200 (CO250) will turn green anytime that the spindle triangles on the front escutcheon are out of alignment or the mechanical key switch is...
When unlocking the CO200 door by mechanical key override, the green led will be continuously ON until the key is released. This will occur after firmware CO.A.6 (or later) has been installed int...
No, we do not recommend using a keypad lock on your gate. Although the keypad side is meant to be on an exterior door, the interior side of the lock should not be exposed to weather. Any exposure t...
The E201 message can be ignored and all normal SUS and lock functions will be maintained.  Click "OK " and continue. Update the Schlage Utility Software (SUS) to version 4.6.0 or highe...
Check that the reader is fully seated into the front escutcheon.
Check that there are no bent pins in the reader connector.
Check that the through door ribbon cable is properly plugged in.
Check that the battery or wired power is properly connected.
Check that the batteries are inserted into the battery holder in the correct polarity orientation.