ND LOCK FINISHES

RELATED FAQS

Question
Answer
As standard the ND lock is not available in a 609 finish.
ND-series locks manufactured on or after January 30, 2017 will ship with an improved spring cage and matching lever design. The design features are noted below. Because of this change, there a...
NOTE: ND locks manufactured on or after January 30, 2017 will no longer make use of the soft durometer spacer. The improved spring cage and matching lever eliminates the need for this spacer. ...
Schlage ND-Series tailpieces for extended doors are available by only two means, but are not available to order separately.   If an extended tailpiece is needed, then a complete lock ...
The lever removal tool can be used to remove levers in both the ND and the L Series mortise locks.
On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project.  This tool can be used for Schlage ND-Series ...
The old D series lever lock was replaced by the ND lock in September 2003.
ND locks can be extended up to 6" Extended Outside.  
On ND-series locks manufactured on or after January 30, 2017:The ND FSIC lever part number is 03-232.  You will need to specify the design and finish.
On ND Series locks manufactuered prior to January 30, 2017:The ND FSIC lever part number was 03-032.  
For modular designs: All functions except ND85 the tailpiece part number is N523-022. The ND85 tailpiece part number is N523-123. For non-modular designs: All functions except ND85 the t...