poor card read range

RELATED FAQS

Question
Answer
See attachment for details: Smart readers support:
See attachment for details: Magnetic Swipe reader supports:
CM locks with a magnetic stripe reader can only be set to read one of the three mag tracks at one time. The CM lock with magnetic stripe reader was shipped from the factory with the magnetic stripe...
All read ranges are affected by the environment the reader and card are subjected too.  The following data was obtained in a relatively "noisy" RF area with the reader mounted on a metal ...
All read ranges are affected by the environment the reader and card are subjected too.  The following data was obtained in a relatively "noisy" RF area with the reader mounted on a metal ...
NDE locks do not have PIV or PIV-I capability at this time.
Customers will need to use the Schlage Utility Software (SUS) on the HHD lock programming device to set the desired magnetic track to be read for access control, if not using default Track 2&n...
The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device "always" has to have a separate PS914-2RS Seri...
All Schlage/XceedID wiegand proximity readers currently understand: -ASK (Amplitude Shift Key) - Used in GE/CASI -FSK (Frequency Shift Key) - Used in HID Prox, AWID, and Lenel The third proximit...
ISOX card technology is no longer supported - contact XceedID sales
For F-series HandPunch devices:    The top-mount PROX reader is available only for the HP-3000 reader.  The PROX reader on a HandPunch 3000 is able to read standard 26-bit ...
See attachment for details: Proximity readers support
When CX99L-BE is not armed with key cylinder on the device or shunted by card reader, the exterior 996LBE lever trim will release.
If a hand reader has an ethernet or modem card installed, the RS-232 port will be automatically configured as a printer output and RS-232 option removed from the SET SERIAL menu.  In order to ...
If an access control system is not available to test the card output on a hand reader, this card emulation test can be done to verify the card format is correct.  These steps will guide you in...
The part number for the solenoid air valve in the 7900 Series control boxes are: 7901/ES7901 - part# 941 - marked A 7902(S)/ES7902(S) - part# 942 - (2 valves) marked A and B 7949/ES7949 - part...