Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ QEL rated for continuous duty ”

RELATED FAQS

Question
Answer
Is Von Duprin's EL device rated for continuous duty?
The Von Duprin EL devices are rated for continuous duty.
Are the Von Duprin 6000 series electric strikes rated for continuous duty?
All of Von Duprin 6000 series electric strikes have continuous duty solenoids either 12 or 24VDC.
Are the Falcon EL solenoids rated for continuous duty?
The Falcon EL devices can be operated in a continuous duty cycle.
What are the electrical requirements for the Schlage L9000 lock?
Applies to L9090EL/EU, L9091EL/EU, L9092EL/EU, L9093EL/EU, L9094EL/EU, L9095EL/EUThe Schlage electrified L-Series wiring diagram can be found here and the re...
Applies to L9080EL/EU. L9082EL/EU (Discontinued)The Schlage electrified L-Series wiring diagram can be found here and the requirements are listed below. 24VAC or 24VDC (maximum 26V, ...
Click here to show the differences of an installed lockcase between the L9090, L9091, L9092, L9093, L9094, L9095 EL/EU and the L9080 EL/EU
What will happen if the voltage on an L lock goes above the 26V maximum range?
Applies to L9090EL/EU, L9091EL/EU, L9092EL/EU, L9093EL/EU, L9094EL/EU, L9095EL/EUOvervoltage will cause the lock to shut down for approximately 5 minutes to allow the circu...
Should a solenoid be hot to the touch?
It is normal for a solenoid to be warm to the touch.
Various situations, such as continuous duty use or application of voltage that is higher than specified, can cause the solenoid to become warm.
If there is concern that the solenoid or device is "too hot" or has the capability to cause injury, disconnect the device and contact a authorized service representative to analyze the opening.