Lead lined frames are intended for use in the X-ray Room locations in Health Care facilities.
Frames are provided by Steelcraft prepped as follows:
Frames are supplied knock-down (KD).
Fram...
39-030 can be used on the A, AL, B250, B500, B600, D, ND, S products.
This kit adapts a square corner latch and a 2 3/4" high square corner strike to 1/2" rabbeted door and frame preparation.
Doors require special downsizing for continuous hinges. The amount of downsizing depends on the hinge specified (manufacturer and type) and the hinge application (Full Mortise versus Full Surface v...
Fire labels (UL, ITS/WHI or FM) are located as follows:
Butt Hinges and Pivots:
On the doors the fire label is located on the hinge edge between the top and 2nd hinge preparation.
On the fram...
To determine Actual Door Size, the following values are subtracted from nominal door size (frame opening/order size)
Actual Door Size: The largest measured width by height of the door leaf as m...
If the door hits the frame (or rubs on the rabbet of the head or jamb) the frame is out of square and improperly installed.
Door edge rubbing on the rabbet - shimming the hinges may resolve the...
The 576A or 576B strikes can be used on wood doors but you should check with door manufacturer if it is a fire-rated door to make sure there are no conflicts.