SCHLAGE CO SERIES EXIT TRIM

RELATED FAQS

Question
Answer
The Von Duprin 994L series trims were square on top and bottom.  They were discontinued in July 2010.
Falcon Monarch XX series trims will work with Monarch 18 series exit devices.
No, the 98/99 series mortise exit device should be ordered as NL less trim. IE, 9875NL-L/TRIM. NL-OP suffix is normally used with the 98/99 series rim, surface and concealed vertical rod devices wh...
 The Falcon Monarch 718C and the 718NL trims can be used on the 25-C exit device.  The 718C trim is listed in the Price Book for the 25 series  The instructions attache...
The device may be ordered as EO, exit only.  That device will have the components needed to interface with the AD and CO exit trim.
Von Duprin 98/99 and 98/99XP Rim/SVR/CVR(steel door only)/Mortise exit devices are compatible with AD200, AD250, AD300, AD400, AD401-993 exit trims.
Von Duprin 22/22F Rim/SVR exit devices are compatible with AD200 and AD250-993 exit trims.
Falcon 25 Rim exit device is compatible with AD200 and AD250-993 exit trims.
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device.  Be sure this screw is installed- Exit hardware and strike must be properly mounted ...
No, the 33A is not compatible with the AD and  CO 993  chassis units. The  33A can only be driven in a clockwise direction. This would restrict it to right hand installs only.
You will need to check with the other manufacturer.  Check the template for the other manufacturer to see if the hole pattern for the trim and the cylinder location would match up.  The VR trim cou...
The 24 series & older 17 Series trims are compatible with each other.