Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Standard power for Falcon EL devices ”

RELATED FAQS

Question
Answer
Is a Von Duprin or Falcon EL device available in 12V?
 Electric latch retraction, EL, devices are only available in 24VDC.
What power supply is need for Falcon EL devices?
The Von Duprin PS914 power supply with either the 900-2RS  or the 900-4RL option board is required.
What power supply is needed for EL devices?
The Von Duprin PS914 power supply must be used on the EL devices with either the 900-2RS or 900-4RL option board since the EL devices requires power supplies set at 24VDC to be able to provide the ...
  You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board  will power 1 or 2 devices that do not require timing from pow...
What gauge wire is needed for CX red and black power wires?
For devices shipped after 8-24-2015 with motor driven:  a.       0-200 ft, use  #18 gauge wire b.      0-500 ft, use #14 g...
For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops:           a.       0-100 ft, use #14 Gauge Wire ...
What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?
  For Product Shipped Prior to August 2012 using the old (black) potted module: a.       0-100 ft 14 gauge wire b.      0-200 ft 12...
 
Can the 8200 power an EL panic device?
The 8200 can not supply the power needed on an EL dev ice. The EL device requires a Von Duprin PS914-2RS or PS914-4RL power supply or the older Von Duprin PS873-2 or PS873-4TD models.
Do you have to specify less dogging on a EL 33A/35A/98/99 series devices?
The standard EL33A/35A and EL98/99 EL devices does not come with mechanical dogging. If the device is specified as a HDEL33A/35A or HDEL98/99 the mechanical dogging will be available on the HDEL...