strike plate kits

RELATED FAQS

Question
Answer
Strike or ridged plate with ridges part number is 970323622.
The 4582 is handed because the latch pocket is not centered on strike plate. the 4582 can't be handed in the field. See attached information: 4582 Handing
The Olivari trim has a warranty of 2 years. This will include mechanical and finish. 
Tamper Alert is typically caused by a missing or misaligned magnet behind the Strike Plate on the door frame on the original NDE locks. There should be two magnets on a plastic strip that get...
There are 2 types of door coordinators available: Bar Coordinators (Ives COR Series): Surface mounted to the bottom surface of the frame soffit. The active door lever, located nearest to th...
The maximum number of stacked glass bead kits is two for panic devices, and one for fire rated devices. State door thickness when ordering devices with glass bead kits. Adding 1/2" of shims t...
A PBKIT is a Pushbar Retrofit Kit.The pushbar retrofit kits are not the same for 33A/35A and 98/99 series exit devices.  Depending on the finish of the exit device, the pushbar end caps are di...
You can only use one GBK Glass Bead Kit (1/4") per device on fire rated openings. Glass Bead Kit is for use on doors with raised glass beads.
A E996 conversion kit is required to convert the 996L/L-BE trim to E996L/L-BE electric trim. 050672-00 is the electric conversion kit for 996L rim or vertical rod exit device. 050673-00 is the ...
There is not a conversion kit to electrify the LP373L lever control.  You need to order a complete E-LP373L-BE control through Engineering Specials.
The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.
We ship the standard installation instructions because it contains enough information to show how to convert the trim from mechanical to electrical.
The 050672 is the part number for rim or vertical rod device and 050673 for the mortise device.
The conversion kit does not contain a new mechanism case cover plate.  If a cover plate is desired you would need the Fire or Less Dogging Cover Plate for EL conversion kit and panic cover plate fo...