user instructions for falcon closure


Falcon is reintroducing the lever return spring for the discontinued Falcon M mortise series.  Effective November 1, 2014 the lever return spring is now available for purchase with a list pric...
Here are some of the major differences between the M and MA-Series.  Lever mounting post holes -  Locations have changed on door template.  (12 and 6 o'clock for M lock, MA lock is approx 1 and...
See the installation instructions 718 for -C devices.
Templates for current 718 series trim can also be found on Falcon website
The current 712L/912L (after 2/28/2011) can be field converted by purchasing the NL Spring part #600339 and following the L to NL function change instructions.
A zero bitted Falcon SFIC core is combinated for the control key to be cut at all 4's.
A PO from a distributor with a letter of authorization from the end user.
In order to manually program a CM lock, there must be a keypad on the reader. If there is not keypad on the reader, then the CM lock can't be manually programmed. Refer to the Schlage 1000 user pro...
Incorrect timing of the lock can cause the outside lever to retract the latch when raised up.  See instructions here (Step 16 and 17) to time a T351, T381, T561, and T571.  Also applies to the same...
To verify the timing on a T561, function test the outside lever after locking it.  To lock the key should only rotate 180 degrees (Not 360 degrees as Schlage does) A properly timed lock will n...
This information can be found at the following URL's: AD200
CO100 CO200
Falcon (19. 24, 25, and XX) parts manuals for Exits are downloadable on the