what height should panic devices be installed at?

RELATED FAQS

Question
Answer
According to ANSI specifications for cylindrical or mortise locks: The lock strike centerline should be 40 5/16" from the bottom of the frame with the lock in relation to the strike.&...
In May 2018, the AD-series and CO-series trims were overhauled to a new full-length body design, replacing the old short-body-with-long-plate trim that had been in use since product launch. T...
Panic Hardware and Fire Exit Hardware are two different types of exit devices, and the proper selection is determined by code requirements. Panic Hardware is an exit device which is tested for u...
The most obvious difference (in the device) is the lack of mechanical dogging on a Fire Rated Device.  There are some internal parts that may be different and the method it is secured to the d...
For compression anchor details refer to the “ANCHORING SYSTEMS”  section in the Steelcraft Tech Data Manual.
An NDE can only be installed on a 1 3/8 inch door if a 1/8 inch shim is installed underneath both the interior and exterior halves of the door. The end user can either fashion one themselves or t...
We don't recommend to use the old style hex dogging kit into the new 98/99 exit device but it would fit as long as the device is not fire rated.
Falcon (19. 24, 25, and XX) parts manuals for Exits are downloadable on the 
 EL devices are wired to the Senior Swing, using the P10 (761465) cable.  Connect the "GRAY" wire to the SC terminal on the 900-2RS card in the Von Duprin Power Supply and the "VIOLET" wire to the ...