what ic core is used for nd locks

RELATED FAQS

Question
Answer
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core).  The tailpiece shown below is used for both...
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.
The ND85/AL85/A85 hotel lock is only available in a conventional Key-in-Lever cylinder.  Interchangeable core and Primus are not available with this function. 
A Primus Hotel cylinder (as well as an IC hotel cylinder) is not possible because there isn't enough room inside the cylinder for all of the required components. 
For ND locks shipping on or after January 30, 2017, the lever and core driver will need to be changed to convert from JD to BD.SFIC lever, 03-200SFIC driver and spacer, 09-774
For ND Locks shipping prior to January 30, 2017:The springcage(s), lever, and core driver will need to be changed.  Depending on the function the components below are required.Outside spring c...
Only the Schlage ND-Series can be prepped to accept non-Schlage cores. All designs are supplied with the appropriate tailpiece Non-Schlage cores are NOT included Lever designs available vary d...
There are two parts that can be referred to as control pins for a 23-030 (FSIC core).C603-967 is the lower control pin that sits in the seventh hole of the FSIC plug. (part B in exploded view) ...
There are several ways to spot differences, see Figure 1, but the easiest is to look at the face of each core. The face of both cores looks like a "figure 8".  With small format, bo...
Yes. Both Schlage and Falcon SFIC mortise housings will accept 6 and 7 pin cores with no additional parts.