Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Where are falcon RW templates ”

RELATED FAQS

Question
Answer
Where is the template for the 718 trims made after 2/28/2011 for Falcon/Monarch concealed vertical rod devices?
See the installation instructions 718 for -C devices.
Templates for current 718 series trim can also be found on Falcon website
What special template (ST) is used with a 4040(XP) Rw/PA mount closer and a GJ overhead stop?
The use of a 62A Shoe (required) would be used to mount a 4040XP Parallel Arm  with a "SURFACE" GJ 70, 79, 81, 90, or 450 series stop. You would order the 4040XP with a Reg w/62A arm op...
Will a 4040 Hw/PA hold open at 180°?
The 4041 Rw/PA and the Hw/PA have the same template.  The only difference is the arm. The 4041/4040XP Hw/PA, if mounted to the 180° template, will hold the door open at 180°. Rw/PA is Regular A...
What template to use for the Falcon MA mortise lock?
The following templates are for the MA lock.  Use the matrix in each template for the specific function.  See here for Sectional trim . See here for Escutcheon trim. 
Where can I find templates for the 237L two point latch device?
Click HERE for the  instruction and template for 237L device.
Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?
The hole should be drilled in the field once the end cap is located on the door.  It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...
Where are hardware templates?
All the templates can be found at us.allegion.com   Please click here