Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ where do you mount EPT ”

RELATED FAQS

Question
Answer
Where is factory recommendation for location of an EPT?
EPT installation guidelines are as follows: Recommended location is 6" below top hinge per template Steelcraft will locate the power transfer prep at the Von Duprin recommended template locati...
Are the mounting tabs for the EPT-2 and the EPT-10 available?
The mounting tabs are not available for the EPT2 or EPT10.
What is the device backset when using a 1790 with a 6111 strike?
The Von Duprin 6111 electric strike would work with DOM 1790 device on medium style doors Centerline of the 1790 device mounting screws are located 1 11/16" from face of stop. See d...
How do you mount a 55 rim with the 379 where the studs do not line up with the mounting screws?
Position the 379L  trim and attach with countersunk screw into the bottom stud of the trim.  Position the 55 Rim device and attach with the device mounting screw through the head of th...
Can you install a 4041 pull side at 180 degrees?
The maximum opening is 120° with the 4041/4041XP standard templating on the pull side of the door.
What side of the door is the 4040SE mounted?
The 4040SE is non handed and can be mounted on the push or pull side of the door.
Can a 4010 be mounted with swing clear hinges?
Locate closer and arm from the centerline of the swing clear hinge pin.
Can you use a 4040SE with swing clear hinges on the pull side?
Pull Side Mount: The 4040SEL X ST-2966 is required for pull side mounting with swing clear hinges. ST-2966 template
Push Side Mount: Take the dimensions for the closer and track from centerline of swing clear hinge pin for the push side mount.
What drop plate is used with a 4040 Rw/PA?
The 4040 Rw/PA can be mounted 3 different ways. The 4040-18 drop plate is used for the regular pull side mount. The 4040-18TJ drop plate is used for the top jamb push side mount. The 4040-18P...
What is the narrowest door a 4010 can be mounted on?
When templated for 140° the 4010 will fit on a 16-1/2" door leaf MINIMUM.