The 1460 Regular Arm part numbers are:
Regular Arm -- 1460-3077 or 1460-3077L for long arm (must specify finish).
Regular Arm with PA -- 1460-3077PA (must specify finish).
Regular Hold Open Ar...
The design change went into effect on 6-16-2011. The stop is now removable and can be changed from one side of the shoe to the other, which makes it a non-handed arm. All arms are shipped standar...
This engineering change did affect the templating of the closer. The stop in the shoe is slightly larger than the original handed cush shoe. The new non-handed arm template locates the closer and s...
ST-3195 is used to obtain the old style EDA or Cush arms which were assembled with threaded studs so that you could take apart the arm assemblies.
Our current standard EDA and Cush arms are rivet...
Pneumatic Automatic Operators are used in areas where electrically operated devices are not convenient or permitted.
Consists of a modified, heavy-duty door closer for manual oper...
This can only be done with universal, non-handed closers: 1250, 1260, 1450, 1460, 4030, 4040XP, and 4050A.You would need an xxxx-62PA shoe to adapt from regular arm to parallel arm mount...
How to: What are the steps to adjust a door closer?Facts: All LCN and FALCON door closers will have 3 regulating valves and a spring adjustment. All closers with a "Delay" feature ...
The hold open position on a "REG" or "EDA" hold open arm is set with the door to a few degrees shy of the desired hold open point. To properly set, open the door 5° less then the desired hold open...
The old 4030 series was:
Handed
Mounted regular arm hinge side.
Had sized springs, were not adjustable.
The 4033 is an obsolete closer. If required, handing can be verified by looking at ...
EDA ARM - The EDA arm is a heavy duty parallel arm mount. The degree of door opening is determined by the template used for mounting. EDA arm closers can only be mounted as a Push Side parallel ar...