Wire diagram for keyswitch

RELATED FAQS

Question
Answer
The product is designed and supported at using up to 30VDC @ 5A.  WARNING: The switch contact itself is rated at 250 VAC @ 5A, but as the chassis is not insulated from the switch, im...
The MA lock can be specified in a 12 or 24V DC configuration (default is 12V). Additionally, an AC power source may be used as long as a rectifier is installed in the circuit (not provided). He...
For additional details and a wiring diagram see the MA service manual page on electrical requirements here.
 The 10-042 is an electric strike used for cylindrical and tubular latch sets.    VOLTAGE  24 VAC  12 VDC &n...
As of June 2011 the electrified T locks can support 12 or 24 Volts.  You do not need to specify 12 or 24 when ordering since the solenoid is capable of either voltage out of the...
Prior to June 2011 the T lock only supported 24V and the electrical requirements were as follows: 0.185 amp @ 24VDC Wire Gage 22 AWG See wiring diagram here - (Previous 2 wire versi...
Wiring and Riser diagrams can be accessed at: Common wiring diagrams can be accessed at:  us.allegion.com Go to "Document Library" > then choose Document type of "Wiring ...
Reference The 914 Installation instructions.
The following common wiring diagrams are available:One Single Door with Panic BarElectric Latch Retraction, with Auto OperatorDelayed egress - Fire Rated ApplicationAuto Operator and actuatorElectr...
Electronic Protocols:Access Control Door with electric trimAccess Control with electric strike Access control with electric strike and LCN 4600 automatic operatorAccess Control with remote Loc...